Description
W119F Bar Mix Flex
PUROTOUCH®
Our W119F Flex Bar Mix accompanies our W119 Bar Mix.
This 3D wall covering employs the thinner slats from our W111 Bar design, and broader slats from our W116 Bar XL design. The thin bar intersperses with the broader bar, with each 25cm wide section having 2 thin and two wide slats.
When trimming these profiles choose between our CX190F and SX194F edge profiles. Use one tube of our FDP700 adhesive to install 3 lengths of W119 Bar Mix profiles. Use our FL300 filler to make clean joints along the 2 metre lengths, and FX400 joint adhesive where the 25cm pieces butt up together.
Use 2 lengths of W119 Bar Mix to cover one square metre of wall. When installing the profile on a flat wall choose the matching W119, the cost effective rigid version of this profile.
Recommended Adhesives
We recommended the use of FX400 and FDP700 Orac adhesives along the length of our profiles to ensure a good installation. On smaller Orac profiles being installed onto dry walls and ceilings (where any new plaster has had at least 6 months to thoroughly dry out) FDP500 can be used to fix mouldings, and FL300 can be used as a filler, which is especially useful for smoothing off external corners (once FX400 has cured) and on joints with uneven ceilings. Please visit the product pages in the Adhesives section for further information.