Orac CX190 – Flexible U Profile

200 x 3 x 2 cm

This flexi versatile U profile has a variety of applications.




Orac CX190 – Flexible U Profile


Designer: Orio Tonini

Building on the success of the Orac Modern Collection the CX190 profile was introduced as part of the Modern 2.0 collection. This versatile U profile has a variety of applications.

The primary function being that of an indirect lighting profile. In this instance one of the 20mm high walls would be glued to the wall a short distance from the ceiling. For best results the inner recess requires an aluminium profile to disperse the heat emanating from the LED tape. Once the LED is fitted into the channel and wired to the driver our CX190 will create neat architectural lines of light. When used as an uplighter beneath atriums, or conservatory roofs the best effects will achieved by adding an opal diffuser over the LED tape.

In addition the CX190F can be used as a miniature skirting board, where the U channel is placed against the wall and creates a 30mm high profile which stands 20mm off the wall. The empty channel behind can be used to hide small cables, such as retro-fit broadband wiring or Hi-Fi cables.

The most daring use of CX190F it’s possible to suspend the profile on wires, and create DIRECT lighting channels, offering LED lighting to offices and corridors. Always remember to shield the LED tape with an aluminium bar or reflective tape, which will avoid any unsightly light egress and also promote longer LED life.

An additional function of our CX190 is as a delicate trim to finish off the edges of trimmed W108 Zig Zag wall panelling.

CX190F minimum flex radii are 30cm and 130cm. Please see the Flexible Mouldings PDF for more details.

*On profiles where we show two radius dimensions please use the tighter radius to show flexibility of the profile when curved through the narrower section. The wider diameter applies to the products flexibility across the wider profile.

Recommended Adhesives

We recommended the use of FX200, FX210 for butt and mitre joints, and FDP700 Orac adhesives along the length of our profiles to ensure a good installation. On smaller Orac profiles being installed onto dry walls and ceilings (where any new plaster has had at least 6 months to thoroughly dry out) FDP500 can be used to fix mouldings. Please visit the product pages in the Adhesives section for further information.

FX200, FX210, FDP500 and FDP700 Orac Adhesives

Recommended Mitre Boxes

FB300, FB13 and FB10 Orac Mitre Boxes

Technical Info


Width: 3cm

Height: 2cm

Length: 200cm

Finish: White Primer (to be finished in a paint of your choice)

Minimum Flex Radii: 30cm and 130cm

Product Resources


Product Video

French Paneling with Orac Decor Video

Orac Product Installation PDF